Set The Date And Time - BT Graphite 2500 User Manual

For each additional handset and charger:
1. Plug the mains power adaptor (item code 052300) into the
power socket on the back of the charger and secure the cable
behind the retaining clip. Plug the other end into the mains
power wall socket and switch the power on.
2. Remove the protective film from the handset screen and
activate the batteries by pulling the plastic tab away from
the back of the handset.
The display will show the handset number, 2, to show it is
registered to the base.
3. Place the handset on the charger. It will beep when placed
in and the battery icon on the handset will flash to indicate
charging. You should let the batteries charge continuously for
at least 24 hours.
Any additional handsets supplied as part of a multipack
are pre-registered to the base. So, once charged, are ready
for use.

Set the date and time

Redial
Menu
1. Press , scroll
Calls
DATE/TIME is displayed. Press
2.
3. Use the keypad to enter the date in the format (DD/MM/YY),
e.g. 12/08/10 for 12th August 2010. If you make a mistake
Secrecy
press to delete.
Menu
4. Press
. Use the keypad to enter the time in the 24 hour
format (HH:MM), e.g, 17:25 for 5.25pm.
Menu
5. Press to confirm.
Your BT Graphite 2500 is now ready for use.
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp
Mains power adaptor.
to CLOCK/ALARM and press
Menu
.
Cable
retaining
clip
Menu
.
8