Konica Minolta bizhub C35 User Manual page 112

[AIDC Mode]
[Thick Mode]
[Engine DipSW]
[Engine DipSW 1] -
[Engine DipSW 28]
[Main Scan Adjust]
[Main Scan Page]
[Admin Settings]
Settings [Mode 1] / [Mode 2]
Select the AIDC operation mode.
[Mode 1]: Standard mode
[Mode 2]: Low mode
Settings [Quality Mode] / [Speed Mode]
In order to prevent toner from clogging within
the developer unit as a result of it being driven
at half-speed, select the timing for driving the
developer unit at full speed for a fixed length of
time when thick paper is being fed.
[Quality Mode]: While printing on thick paper,
printing is periodically paused, and the devel-
oper unit is driven at full speed for a fixed
length of time. Since printing is paused, the
quality is not affected; however, a standby time
of approximately 70 seconds occurs every 400
seconds or so of half-speed operation.
[Speed Mode]: While printing on thick paper,
only the drive of the developer unit periodically
switches to full speed for a fixed length of time.
Since printing continues during full-speed
drive, the print quality is slightly affected, how-
ever the standby time is short.
Change the DIP switches to control machine
operation.
Settings [ON] / [OFF]
Use to change engine settings.
Normally, there is no need to change the
settings. If it becomes necessary to
change the settings, do so according to
the instructions from the service
representative.
Adjust the scanning settings.
Settings [Print] / [Cancel]
Print the test pattern for fine adjustment of the
color ratios in the main scanning direction.
3-67