Chapter 2 - Programming The Interface; Introduction; Programming The Interface - Plug And Play; Keyboard Wedge Connection - Honeywell 2020 User Manual

2
Programming the Interface

Introduction

Chapter 1 describes connecting the base to the computer with the appropriate
interface cable. This chapter describes how to program your system for the
desired interface.

Programming the Interface - Plug and Play

Plug and Play bar codes provide instant image scanner set up for commonly
used interfaces.
Note: After you scan one of the codes, power cycle the host terminal to have
the interface in effect.

Keyboard Wedge Connection

If you want your system programmed for an IBM PC AT and compatibles key-
board wedge interface with a USA keyboard, scan the bar code below. Key-
board wedge is the default interface.
Note: The following bar code also programs a carriage return (CR) suffix.

Laptop Direct Connect

For most laptops, scanning the Laptop Direct Connect bar code allows opera-
tion of the image scanner in parallel with the integral keyboard. The following
Laptop Direct Connect bar code selects terminal ID 03, programs a carriage
return (CR) suffix and turns on Emulate External Keyboard
IBM PC AT and Compatibles
with CR suffix
Laptop Direct Connect
with CR suffix
(page 2-13).
2 - 1