Illumination Lights - Honeywell 2020 User Manual

If you have an aimer delay programmed (see
aimer will be at 100% power during the delay, regardless of the LED Power
Level.
Note: If you scan the Off bar code, both the aimer and illumination lights turn
off, making it impossible to scan bar codes in low light. To turn the LED
Power Level back on, move to a brightly lit area and scan either the Low
or the High bar code below.
Off
* High (100%)

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights
On bar code, below. However, if you want to turn just the lights off, scan the
Lights Off bar code. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set
using Aimer Mode
* Lights On
(page 4-12).
Aimer Delay on page 4-12), the
Low (50%)
Lights Off
4 - 11