Symbology Chart - Honeywell 2020 User Manual

High Priority Symbology
To specify the high priority symbology, scan the High Priority Symbology bar
code below. On the
want to set as high priority. Locate the Hex value for that symbology and scan
the 2 digit hex value from the Programming Chart (inside back cover). Scan
Save to save your selection. Default = None
Low Priority Symbology
To specify the low priority symbology, scan the Low Priority Symbology bar
code below. On the
want to set as low priority. Locate the Hex value for that symbology and scan
the 2 digit hex value from the Programming Chart (inside back cover).
If you want to set additional low priority symbologies, scan FF, then scan the 2
digit hex value from the Programming Chart for the next symbology. You can
program up to 5 low priority symbologies. Scan Save to save your selection.
Default = None
Preferred Symbology Time-out
Once you have enabled Preferred Symbology and entered the high and low
priority symbologies, you must set the time-out period. This is the period of
time the imager will search for a high priority bar code after a low priority bar
code has been encountered. Scan the bar code below, then set the delay (from
1-3,000 milliseconds) by scanning digits from the inside back cover, then
scanning Save. Default = 500 ms.
Preferred Symbology Default
Scan the bar code below to set all Preferred Symbology entries to their default
values.
4 - 16

Symbology Chart

High Priority Symbology
Symbology Chart
Low Priority Symbology
Preferred Symbology Time-out
Preferred Symbology Default
on page A-1, find the symbology you
on page A-1, find the symbology you