Rs-232; Wand Emulation Plug & Play - Honeywell 2020 User Manual

RS-232

The RS-232 Interface bar code is used when connecting to the serial port of a
PC or terminal. The following RS-232 Interface bar code also programs a car-
riage return (CR) and a line feed (LF) suffix, baud rate, and data format as indi-
cated below. It also changes the trigger mode to manual.
Option
Baud Rate
Data Format
Wand Emulation Plug & Play
In Wand Emulation mode, the image scanner decodes the bar code then sends
data in the same format as a scanner image scanner. The Code 39 Format
converts all symbologies to Code 39.
The Same Code Format transmits U.P.C., EAN, Code 128 and Interleaved 2 of
5 without any changes, but converts all other symbologies to Code 39.
The Wand Emulation Plug & Play Code 39 Format bar code below sets the
terminal ID to 61. The Wand Emulation Plug & Play Same Code Format bar
code sets the terminal ID to 64. These Plug & Play bar codes also set the
Transmission Rate to 25 inches per second, Output Polarity to black high, and
Idle State to high. (If you want to change the terminal ID only , without changing
any other image scanner settings, please refer to
Terminal ID Method
Wand Emulation
Plug & Play
(Code 39 Format)
2 - 2
Setting
115200 bps
8 data bits, no parity bit, 1 stop bit
RS-232 Interface
on page 2-6.)
Programming the Interface -
Wand Emulation
Plug & Play
Same Code