To Clear One Or All Prefixes Or Suffixes - Honeywell 2020 User Manual

which you want to apply the prefix or suffix. For example, for Code 128,
Code ID is "j" and Hex ID is "6A".
Step 3. Scan the 2 hex digits from the
cover of this manual or scan 9, 9 for all symbologies.
Step 4. Determine the hex value from the
1252) on page A-4, for the prefix or suffix you wish to enter.
Step 5. Scan the 2 digit hex value from the
cover of this manual.
Step 6. Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7. To add the Code I.D., scan 5, C, 8, 0.
To add AIM I.D., scan 5, C, 8, 1.
To add a backslash (\), scan 5, C, 5, C.
Note: To add a backslash (\) as in Step 7, you must scan 5C twice – once to
create the leading backslash and then to create the backslash itself.
Step 8. Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbology.
Example: Add a Suffix to a specific symbology
To send a CR (carriage return)Suffix for U.P.C. only:
Step 1. Scan Add Suffix.
Step 2. Determine the 2 digit hex value from the Symbology Chart (included in
the Symbology Chart,
Step 3. Scan 6, 3 from the
manual.
Step 4. Determine the hex value from the
Codes on page A-7, for the CR (carriage return).
Step 5. Scan 0, D from the
manual.
Step 6. Scan Save, or scan Discard to exit without saving.

To Clear One or All Prefixes or Suffixes:

You can clear a single prefix or suffix, or clear all prefixes/suffixes for a symbol-
ogy. When you Clear One Prefix (Suffix), the specific character you select is
deleted from the symbology you want. When you Clear All Prefixes (Suffixes),
all the prefixes or suffixes for a symbology are deleted.
5 - 2
Programming Chart
ASCII Conversion Chart (Code Page
Programming Chart
beginning on page A-1) for U.P.C..
Programming Chart
Code Page Mapping of Printed Bar
Programming Chart
inside the back
inside the back
inside the back cover of this
inside the back cover of this