Call Channel Programming; Adjusting The Volume Level - Icom IC-M35 Instruction Manual

■ Call channel programming

Call channel is used to access Channel 16 (default; may
differ according to the version), however, you can program
the call channel with your most often-used channels in each
channel group for quick recall.
q Push and hold [CH] for 1 sec. once or twice to select the
desired channel group (U.S.A., International or ATIS) to
be programmed. (p. 9)
w Push and hold [16 C] for 1 sec. to select the call channel
of the selected channel group.
• "CALL" and call channel number appear.
e Push and hold [16 C] again for 3 sec.
(until a long beep changes to 2
short beeps) to enter the call chan-
nel programming mode.
• Channel number starts blinking.
r Push [Y]/[Z] to select the desired
channel.
t Push [16 C] to program the dis-
played channel as the call channel.
• The channel number stops blinking.

■ Adjusting the volume level

The volume level can be adjusted with [VOL/SQL MONI]
and [Y]/[Z].
q Push [VOL/SQL MONI] once to enter the volume adjust-
ment mode, then adjust the volume level with [Y]/[Z].
• "VOL" indicator starts blinking.
• The transceiver has 31 volume levels and OFF.
• With no key operation is performed for 5 sec., the transceiver
returns to the normal condition.
w Push [VOL/SQL MONI] twice to exit the volume adjust-
ment mode.
Blinks while adjusting the volume level.
BASIC OPERATION
Indicates the
volume level.
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
11