Testing The Treadmill Operation - CYBEX 750T Owner's Manual

WARNING: Be sure that all electrical requirements are met as indicated in the specifi cations at
the front of the manual and at the beginning of this chapter prior to proceeding.

Testing the Treadmill Operation

Use the following instructions to test the full speed and incline range of the treadmill and to check the belt
for proper operation.
CAUTION: During this procedure STAY OFF THE RUNNING BELT! Stand with your feet on the two
steps.
NOTE: Cybex recommends that the treadmill be unplugged or the on/off (I/O) power switch turned off (O)
when it is not in use.
1. Without anyone on the treadmill, plug the power cord into a power outlet from a grounded, dedicated
circuit as described under Electrical Requirements in this chapter.
NOTE: Ensure the power cord is not being pinched under the front of the treadmill.
2. Locate the on/off (I/O) power switch in the front motor cover of the treadmill. Toggle it to the on
position (I).
3. The control panel will light up and be in the Dormant Mode.
4. Press the Quick Start key. The treadmill begins a countdown "BELT START IN 3...2...1" and sounds
a tone for each count. After it reaches one (1), the treadmill gives a longer tone and then begins
accelerating the belt to reach 0.5 mph (0.8 kph).
5. The lower left display will show the incline then time and the lower right display will show the actual
speed.
6. Press and hold down the Speed + key until the treadmill reaches a speed of approximately 4 mph
(6.4 kph), as indicated on the display.
7. Observe the belt to see that it is running properly; it should stay centered in the middle of the deck. If
you have problems with the running belt operation, see Running Belt Adjustments in the Preventive
Maintenance chapter.
8. Run the treadmill through its full speed range. First press the Speed + key until the treadmill reaches
its highest speed. Then press the Speed - key until the treadmill is back to 0.5 mph (0.8 kph).
9. As you press the Incline
or speed.
10. When the treadmill reaches the set incline and speed, the displays will remain steadily illuminated to
indicate that the desired settings have been reached.
11. Run the treadmill through its full % grade range. Press the Incline
its highest grade (15%). Then press the Incline
12. Press the Stop key to stop the running belt, end the workout review and return the display to
Dormant Mode.
Assembly
and
Setup
Page 2-10
Cybex 750T Treadmill Owner's Manual
or Speed + - keys, the respective displays will show the actual incline
key until the treadmill reaches -3% grade.
key until the treadmill reaches