Error Codes - CYBEX 750T Owner's Manual

Error codes are stored in a log of 20 entries, each stamped with time and date with the most recent being
the fi rst in the log, the oldest the last in the log. Error codes are displayed in the following format: [Log
Entry #] [Actual Error Code #] [Time] [Date], "ERR 1 141 03:49 1/14/2007".
Press the Incline Control Keys to increment / decrement the Log count to view the next or previous error.
While displaying the error log press and hold the CLEAR button for three seconds to clear all errors. The
display will show "NO ERRORS" when cleared.
• ERROR 1 - No Speed at Startup.
with a belt speed within timed limits.
• ERROR 3 - Speed Irregularity.
or a speed of zero after a correct speed had been established.
• ERROR 5 - Drive Communications Lost.
drive has not given a valid response in 350 ms.
• ERROR 6 - Speed Irregularity/Overspeed.
the startup, yet the drive begins sending values outside the expected it is reported as belt speed lost.
• ERROR 7 - Controller Over-Current (Fold-back).
from the drive that is outside of desired parameters.
• ERROR 8 - Approaching Over-Temperature.
• ERROR 9 - Display watchdog triggered.
• ERROR 92 - Over Current (Output).
• ERROR 93 - Over Voltage (DC Link).
• ERROR 94 - Over Heat (Heatsink).
• ERROR 95 - Low Voltage (DC Link).
• ERROR 96 - Thermal Integrator of output current.
line.
• ERROR 98 - Display Communications lost.
communications with the display, where the display has not sent a valid response in 400 ms.
• ERROR 99 - Display Communications lost.
communications with the display, where the display has not sent a valid response in 400 ms.
• ERROR 103 - Input Current OC trip (110 VAC only).
line.
• ERROR 105 - Thermal Integrator of Input Current (110 VAC only).
range.
• ERROR 140 - Can not fi nd home position on power-up.
the zero position switch during power up.
• ERROR 141 - Can not fi nd home position in normal use.
the zero position switch during use.
• ERROR 142 - Out of incline range (over 15% or lower than -3%).
switch report that is outside of expected limits.
• ERROR 150 - Out of Speed Range (over 150hz).
over the expected speed.
Cybex 750T Treadmill Owner's Manual
The display commanded a belt start but the drive did not respond
The drive is reporting a slower speed than the display is commanding,
The display lost communications with the drive, where the
If the display has received good belt speed information at
If the display receives motor current information
Internal controller temperature too high.
If the Display Watchdog is triggered the console will reboot.
Controller output current too high.
Internal controller voltage too high.
Controller temperature too high.
Drive measures a low voltage on the input line.
Drive measures a high current peak on the output
Without drive belt movement. The drive lost
With drive belt movement. The drive lost
The display receives a report of belt speed that is
Drive measures a high current peak on the input
Input current is out of expected
The display does not receive a signal from
The display does not receive a signal from
The display receives a position
Operation
Page 3-13