Figure 6 - CYBEX 750T Owner's Manual

D. Repeat steps 7A to 7C for the right upright.
E. Using a 1/2" box end wrench, fully tighten the two bolts, 5/16-18 x 2.25", HXHD (#22) and four
nuts (#24) securing the console assembly to the uprights. See Figure 4.
F. Using a 9/16" Socket wrench, fully tighten the ten bolts, 3/8-16 x .625" (#20) securing the uprights
to the base assembly (#1). See Figure 3.
8. Install the Display Cable.
NOTE: Do not pinch or damage display cable
when installing.
A.
Locate the display cable exiting the
back of the console assembly.
B.
Insert the display cable into the top of
the left upright (#3) until it exits at the
base of the upright (#3). See Figures
5 and 6.
C.
Plug the display cable, located at the
bottom of the upright assembly (#3)
into the hub board connector J3. See

Figure 6.

NOTE: If installing the A/V option, refer to
the 750T A/V bracket installation
instructions (supplied with the A/V
bracket).
Assembly
and
Setup
Page 2-6
Cybex 750T Treadmill Owner's Manual
Display
Cable
Figure 5
Hub Board
Connector J3
Figure 6
#3
Display
Cable
#3