CYBEX 750T Owner's Manual page 34

6. The treadmill begins a countdown, "BELT START IN 3...2...1," and sounds a tone for each count.
When it reaches one (1) the treadmill gives a longer tone and then starts accelerating the belt. In
Manual Mode the belt will begin accelerating to 0.5 mph (0.8 kph) and the incline will remain at zero
percent. In a program the belt will begin accelerating and the incline will change to the corresponding
speed and incline of the program and level you selected.
7. Hold the handrails while you step onto the running belt and begin walking.
8. Observe the control panel. The top center Bar Graph display shows a graphical representation of
the relative incline changes, and if in a program, will show the relative intensity changes that are
coming up. The Text Area will start showing the workout data such as Distance, Calories, Heart
rate (if available), METs and Pace (Minutes per Mile or Minutes per Km). The data displays will start
by automatically shifting every fi ve seconds. To hold on one display, press the Shift/Scan key. To
continue auto-scan, hold the Shift/Scan key for 3 seconds until it beeps.
NOTE: Heart rate will be displayed in lieu of METs if a valid heart rate is available from a wireless chest
strap (not included) or by holding the contact heart rate grips.
NOTE: When you adjust incline in a program, the change will affect only the current segment. The
program control will resume starting with the next segment. To increase or decrease overall
intensity, adjust the speed and/or the program level.
9. Press the Speed + – keys to change the belt speed at any time. The right display will show the set
speed.
10. Press the Incline
incline only when incline keys are used, then revert to time.
11. Press the Stop key at any time to stop the workout. Press Stop once to end the workout and begin
the Workout Review. As you press Stop once, the treadmill belt will stop. Press Stop a second time to
clear the Workout Review, return to Dormant Mode and return incline to 0%.
12. If the e-stop key is removed during a workout, the drive motor power shuts off immediately, causing
the belt to stop. "EMERGENGY STOP" is displayed, followed by "REPLACE E-STOP KEY TO
CONTINUE". Replacement of the e-stop key causes Workout Review to begin.
13. When a program is complete the treadmill begins a countdown, "BELT STOP IN 3...2...1," and sounds
a tone for each count. The belt slows to a stop and Workout Review is displayed for the preset time or
until you press the Stop key.
14. The treadmill returns to Dormant Mode and the incline returns to 0%.
Operation
Page 3-4
Cybex 750T Treadmill Owner's Manual
keys to change the incline at any time. The left display will show the current