Denon AVR-4810 Owner's Manual page 49

Making the Network Settings (Network Setup)
Make network settings.
Setting items
Network Connecting
Make settings for wired or
Use this procedure to configure the Wireless LAN settings.
wireless LAN.
1. Fitting a rod antenna (vpage 25 "Connecting to a Home Network
(LAN)").
If a LAN cable is connected, remove it.
b
2. Turn on the AVR-4810 (vpage 27 "Turning the Power On").
3. Set the access point at the "Network Connecting".
When searching access points to connect automatically, refer to
"Automatic settings".
When searching access points to connect manually, refer to "Manual
settings".
Automatic settings
n
NETWORK CONNECTING
Select a connection method appropriate for your
wireless LAN host
Search
WPS
Manual
Search and set the access point
q On the GUI menu, select "Network Connecting" – "Search" and press
ENTER
.
The access point you have set is displayed.
w Use ui to select the access point, and then press
The DHCP function is disabled.
Main remote control unit
operation buttons
Default settings are underlined.
Setting contents
Wireless LAN settings
q
Enter Cancel
RETURN
NETWORK CONNECTING
w
Please select access point to connect.
DENON WEP
Search
Enter Cancel
RETURN
Select access point to connect
ENTER
.
:Displaying the menu
Cancel the menu
Setting items
Network Connecting
(Continued)
e If there is an encryption setting for the access point you selected in
82%
r When encryption is by "WEP", select the "Default Key" using
:Moves the cursor
:Confirm the setting
(Up/Down/Left/Right)
Making Detailed Settings (Manual Setup)
Setting contents
If the access points are repeat search, use
b
ENTER
and press .
NETWORK CONNECTING
Please select access point to connect.
DENON WEP
Select
Search
Enter
RETURN
Select access point to connect
step w, enter same encryption key as used for the access point. (If
there is no encryption setting, proceed to step t.)
NETWORK CONNECTING
Enter same encryption key (security) key as used
for access point
AAAAA
WEP Key
Default Key 1
r
Connection
t
Enter
RETURN
Enter encryption key
uio p
Use to input the "Key" (encryption key) and press
Enter the same encryption key as used for the access point.
The types of characters that can be input are as shown below.
GLower case charactersH abcdefghijklmnopqrstuvwxyz
GUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZ
GSymbolsH ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ˆ _ ` { | } ˜
GNumbersH 0123456789 (Space)
• You can change the character type when you press
MENU
main remote control unit or during character input.
• When no security settings have been used in the Internet connection
settings, this step is not necessary.
then press o p .
1 / 2 / 3 / 4 : Select the same default key as used for the access point.
This should normally be set to "1".
:Return to previous menu
ENGLISH
i to select the "Search"
82%
Cancel
e
Cancel
ENTER
.
SEARCH
on the
i , and
See overleaf