Table of Contents
Advertisement
If the two shapes peel off together or show other problems with cutting, adjust the blade force and perform a cutting
test a second time. First, change the blade force.
Changing the Blade Force
After you have changed the blade force, to avoid wasting material, move the cutting carriage to the location right next
to where you just performed the cutting test.
To move the cutting carriage, use the cursor keys.
FORCE 50 gf
2
1
FORCE 50 gf
1
*60 gf
2
FORCE 60 gf
20 cm/s
60 gf
0.250 mm
4-1 Practicing Cutting Using the Test-use Material
Make sure the [PEN FORCE] slider is centered
(at "0" on the scale).
Press
Press
USE
for the value.
Press
Press
screen shown at left.
A
Chapter 4: Performing Cutting
.
.
to make the setting
to enable the setting.
or
to go back to the
Continued on the next page
43
Hide quick links:
Advertisement
Table of Contents
