2.
Install the blade holder.
Insert until the collar is
flush with the surface.
This completes the procedure for installing the blade. Go on to "Step 3: Optimizing the Cutting Quality for the Mate-
rial."
p 42 "Step 3: Optimizing the Cutting Quality for the Material"
4-1 Practicing Cutting Using the Test-use Material
Cutting carriage
Screw
Support it from below.
Loosen the screw of the cutting carriage.
Support the screw from below and insert the
blade holder.
If installed without supporting the screw in this way,
cutting quality may become poor.
Tighten the screw.
Tug the blade holder upward to make sure it does not
come loose.
Chapter 4: Performing Cutting
41