Roland GX-24 User Manual page 39

Move the pinch rollers so that they are positioned at the edges of the material and also inside the
areas of the pinch-roller position-verification marks.
Be sure to position the left
pinch roller inside the area
of the wide mark.
Be careful to position the pinch rollers so that they are not too close to the edges of the material and do not
extend beyond the edges of the material.
Pinch-roller position-
verification mark
Pinch roller
Guide line
Guide line
Important Notes
Do not use excessive force when moving the loading lever. Doing so may damage it.
If the condition of the material is as described below, then stretch or flatten it before use.
•The material is curled upward.
•The leading edge of the material is bent or creased.
4-1 Practicing Cutting Using the Test-use Material
OK
Do not extend beyond
the mark.
Align the left edge of the material so that it lies parallel to
the guide lines.
Raise the loading lever.
The material is secured in place.
Pinch roller
Not OK
Chapter 4: Performing Cutting
Pinch-roller position-
verification mark
37