Table of Contents
Advertisement
28
What to do if...
2. Pull the door trim to the front to remove
it.
3. Hold the door glass panels on their top edge one by one and pull them upwards out of
the guide
4. Clean the door glass panels.
To install panels follow the procedure in reverse. Insert the smaller panel first, then the
larger.
What to do if...
Problem
The cooking zones do not op-
erate
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven does not heat up
The oven lamp does not operate The oven lamp is defective
F11 appears in the clock display The meat probe has short cir-
The time display shows an error
code which is not in the list
If you can not find a solution to the problem, refer to your dealer or the Service Force
Centre.
WARNING!
Let a qualified electrician or competent person do repairs to the appliance.
Possible cause
Consult the operating instructions for the built-in cooking sur-
face
The oven is not switched on
The clock is not set
The necessary settings are not
set
The fuse in the fuse box is re-
leased
cuit or the plug of the meat
probe is not tightly in position
in the socket
Electronic error
Remedy
Switch on the oven
Set the clock
Control the settings
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
Replace the oven lamp
Insert the plug of the meat
probe as far as it will go into the
socket on the side wall of the
oven
Switch the appliance off and on
again through the fuse or the
safety switch in the fuse box. If
the display shows the error
message again, refer to the
Service Force Centre
Advertisement
Table of Contents
