Abit BE6 User Manual page 89

Installing the driver for Ultra ATA/66
! If you boot from a floppy and type "WINNT /B" to install the Windows NT 4.0, the
installation steps are similar to the above steps. You only have to pay attention to two
things. Firstly, don't format your hard disk with the FAT32 file system. Otherwise,
you will not be able to install Windows NT. Secondly, after the files have been copied
to the hard disk, the system will reboot. On the reboot, press "F6" immediately when
the message "Setup is inspecting your computer's hardware configuration..."
appears
! If you install a general drive to IDE1 (or IDE2) and an Ultra ATA/66 drive to IDE3
(or IDE4), we suggest you don't format your general drive with FAT32 file
system. Otherwise, you will encounter some problems when you install Windows NT
on Ultra ATA/66 drive because the Windows NT have to write some data to the drive
that connect to the IDE connector. But Windows NT can't access the drive that format
with FAT32 file system.
*
Floppy Install:
If the NT 4.0 is first installed on the ATA/66 drive connected to IDE3 or IDE4, follow the
following installation procedure:
Step 1: Set your system to boot from "Drive A" and then insert the Windows NT installation
diskette 1/3. Power on your computer.
Step 10: After you have finished Windows
NT installation and entered Windows NT,
you can enter "Control Panel" ) "SCSI
Adapters". If the Ultra ATA/66 IDE
controller is installed correctly, you will see
the figure on the left.
NOTE
D-9
User's Manual