Abit BE6 User Manual page 19

Installing the Motherboard
WOL1: Wake on LAN Header
Note: Watch the pin position and the orientation
SMB1: System Management Bus Connector
master gets priority.
Note: Watch the pin position and the orientation
CON2 header:
chipset as possible and avoid having it near the CPU FAN.
If you have a Network adapter that supports
this feature, then you can connect the
specific cable from the network adapter to
this header. This feature lets you wake up
your computer via remote control through a
local area network. You may need a specific
utility to control the wake up event, like
®
using the Intel LDCM
similar utilities.
This connector is reserved for system
management bus (SMBus). The SMBus is a
specific implementation of an I
a multi-master bus, which means that
multiple chips can be connected to the same
bus and each one can act as a master by
initiating a data transfer. If more than one
master simultaneously tries to control the
bus, an arbitration procedure decides which
This header is for you to connect an
additional thermistor to detect the CPU
temperature. You can attach one end of the
two-threaded thermal cable that comes with
the motherboard to CON2 header, then tape
the other end of thermal cable on CPU's heat
sink.
Generally speaking, the location you tape
the thermistor should be as near the CPU
2-9
®
utility or other
2 2
C bus. I C is
User's Manual