Abit BE6 User Manual page 86

D-6
Windows NT 4.0
Installing drivers during Windows NT installation:
*
CD-ROM disk Install:
The following instructions explain how to install the Ultra ATA/66 driver, while installing
Windows NT 4.0.
Step 1: When you power the computer on, you will see the following message appear
briefly at the bottom of the screen during POST:
PRESS DEL TO ENTER SETUP
Please press the DEL key immediately to enter the BIOS setup utility.
BE6
Step 9: Click "No" to continue updating
another "PCI Mass Storage Controller"
driver. The installation procedure is the
same as Steps 3 to 10. After updating
another controller driver, the system will ask
you to restart your computer. Click "Yes" to
restart your computer.
Step 10: After your system has restarted,
you can enter "Control Panel" ) "System",
and then select "Device Manager" )
"SCSI Controllers". If Ultra ATA/66 driver
is installed correctly, you will see the figure
on the left.
Step 2: Select "BIOS FEATURE SETUP"
after you enter BIOS setup utility. Then set
the "Boot Sequence" as "CDROM,C,A"
(refer to figure left).
After you finished the setting, please
remember to save it.
Appendix D