Using Static Routes; Static Route Example - NETGEAR Wireless-N 150 User Manual

Using Static Routes

Static routes provide additional routing information to your router. Under normal circumstances,
the router has adequate routing information after it has been configured for Internet access, and
you do not need to configure additional static routes. You must configure static routes only for
unusual cases such as multiple routers or multiple IP subnets located on your network.

Static Route Example

As an example of when a static route is needed, consider the following case:
• Your primary Internet access is through a cable modem to an ISP.
• You have an ISDN router on your home network for connecting to the company where you are
employed. This router's address on your LAN is 192.168.0.100.
• Your company's network address is 134.177.0.0.
When you first configured your router, two implicit static routes were created. A default route was
created with your ISP as the wireless modem router, and a second static route was created to your
local network for all 192.168.0.x addresses. With this configuration, if you attempt to access a
device on the 134.177.0.0 network, your router forwards your request to the ISP. The ISP forwards
your request to the company where you are employed, and the request is likely to be denied by the
company's firewall.
In this case you must define a static route, telling your router that 134.177.0.0 should be accessed
through the ISDN router at 192.168.0.100. The static route setup would look like
In this example:
• The Destination IP Address and IP Subnet Mask fields specify that this static route applies
to all 134.177.x.x addresses.
• The Gateway IP Address field specifies that all traffic for these addresses should be
forwarded to the ISDN router at 192.168.0.100.
• The value in the Metric field represents the number of routers between your network and the
destination. This is a direct connection, so it can be set to the minimum value of 2.
• The Private check box is selected only as a precautionary security measure in case RIP is
activated.
Advanced Configuration
Wireless-N 150 ADSL2+ Modem Router DGN1000 User Manual
v1.1, January 2010
Figure 5-8.
5-13