Connecting Additional Wireless Client Devices After Wps Setup - NETGEAR Wireless-N 150 User Manual

Wireless-N 150 ADSL2+ Modem Router DGN1000 User Manual
Figure 2-6
Using either method, the client wireless device will attempt to detect the WPS signal from the
wireless modem router and establish a wireless connection in the time allotted.
• While the wireless modem router attempts to connect to a WPS-capable device, the Push
'N' Connect LED on the front of the wireless modem router blinks green. When the
wireless modem router has established a WPS connection, the LED is solid green.
• If a connection is established, the wireless modem router WPS screen displays a message
confirming that the wireless client was successfully added to the wireless network. (The
wireless modem router has generated an SSID, implemented WPA/WPA2 wireless
security [including a PSK security password] on the wireless modem router, and has sent
this configuration to the wireless client.)
5. Note the new SSID and WPA/WPA2 password for the wireless network.
To access the Internet from any computer connected to your wireless modem router, launch a
browser such as Microsoft Internet Explorer. You should see the wireless modem router's Internet
LED blink, indicating communication to the ISP.
Note: If no WPS-capable client devices are located during the 2-minute timeframe,
security will not be implemented on the modem router.

Connecting Additional Wireless Client Devices After WPS Setup

You can add more WPS clients to your wireless network, or you can add a combination of
WPS-enabled clients and clients without WPS.
2-16 Configuring Your Wireless Network and Security Settings
v1.1, January 2010