Welcome" Page Displays Instead Of Router Main Menu; Power Led Is Off; Power Led Is Red - NETGEAR Wireless-N 150 User Manual

Wireless-N 150 ADSL2+ Modem Router DGN1000 User Manual
If the ADSL link LED is lit, a link has been established to the connected device. If a LAN port
is connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10 Mbps,
the LED is amber.
If any of these conditions does not occur, refer to the appropriate following section.

"Welcome" Page Displays instead of Router Main Menu

This situation can occur if the CD Setup Wizard does not complete successfully; the unit will stay
in "Wizard Mode". If the "Welcome" page displays instead of the main menu when you try to go
to the Internet or log into the wireless modem router, you can bypass the wizard using one of the
following methods:
• Log into the wireless modem router at http://routerlogin.com/basicsetting.htm.
• Perform a factory reset to take the router out of "Wizard Mode" altogether.

Power LED Is Off

If the Power and other LEDs are off when your router is turned on:
• Make sure that the power cord is properly connected to your router and that the power supply
adapter is properly connected to a functioning power outlet.
• Check that you are using the 12 V DC power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact Technical Support.

Power LED Is Red

When the router is turned on, it performs a power-on self-test. If the Power LED turns red after a
few seconds or at any other time during normal operation, there is a fault within the router. The
Power LED also turns red when you press the Wireless On/Off and WPS buttons on the side panel
of the wireless modem router simultaneously for 6 seconds, and blinks red 3 times when you
release these buttons. However, in this case, the wireless modem router is working normally.
If the Power LED turns red to indicate a router fault, turn the power off and on to see if the
wireless modem router recovers.
If the power LED is still red 1 minute after power up:
• Turn the power off and on to see if the wireless modem router recovers.
• Clear the router's configuration to factory defaults. This sets the router's IP address to
192.168.0.1. This procedure is explained in
6-2
"Factory Settings" in Appendix
v1.1, January 2010
A.
Troubleshooting