Connecting To A Tv Using An Hdmi Cable - Philips HDR5750 User Manual

Connecting to a TV Using an HDMI cable

• HDMI outputs the Video / Audio signals without converting to Analog signals.
• No Audio connection is required.
• High Speed HDMI cable (also known as HDMI Category 2 cable) is recommended for Better Compatibility.
• Use an HDMI cable with the HDMI logo (a certified HDMI cable) for this connection.
Do Not Tilt the Connector when inserting it into the HDMI jack
and make sure the Shapes of the Jack and the Connector are
matched.
■
Supplied cables used in this connection are as follows:
• RF Coaxial cable x 1
Please purchase the rest of the necessary Cables at your local store.
Note(s)
• Some Devices with an HDMI input may not operate properly with this unit.
• When using an HDCP-incompatible Display Device, the Image will not be viewed properly.
• The Audio signals (including the sampling frequency, the number of channels and bit length) from the HDMI connector may
be limited by the Device that is connected.
• When this unit's HDMI connector is connected to a DVI-D compatible monitor (HDCP compatible) with an HDMI-DVI
converter cable, the signals are output in digital RGB.
• When a Power Failure occurs or when you Unplug the Unit, some problems with the HDMI setting might occur. Please
Check and Set the HDMI Setting again.
HDMI OUT
HDMI cable
(not supplied)
Rear of this Unit
ANTENNA ANTENNA
AUDIO
R OUT L VIDEO OUT
IN IN
HDMI OUT
HDMI OUT LAN USB
OUT ( HDD )
OUT
HDMI IN
ANT. IN
ANTENNA
IN
RF Coaxial
cable
OUT
This Connection
is for TV Pass
Through Only
or
RF Coaxial
cable
Cable TV
Continued on next page.
VHF / UHF
antenna
EN - 15