Outputting The Sound Of This Receiver To An External Device; Line Output Setting - Pioneer LX03BD Operating Instructions Manual

09 Other connections
2 LINE Select an audio input source.
Input sources are cycled through as shown
below:
Digital 1 OPT
Digital 2 OPT
3 If necessary, start playback of the
external source.
Outputting the sound of this
receiver to an external device
You can use the ANALOG AUDIO OUT jacks
to connect an analog audio component, such
as a tape player, and record the sound of the
receiver's tuner, etc.
Tape player, etc.
AC IN
(LX03BD)
Note
1 • When the Line Output is switched to Lt/Rt, the sound function will be fixed at the current setting and cannot be changed.
The display will briefly flash Line Out Mode if an attempt is made to use a prohibited function.
• When the Line Output is to Lo/Ro(Stereo), the audio from the analog output jacks may be interrupted, depending on the
operation.
• When using DTS multi-channel sound sources, output is in Lo/Ro(Stereo).
48
En
Analog
Digital 3 COAX
To
analog input
IN OUT
CONTROL
R L
FRONT 4 CENTER 4
ANALOG
L
R
R SURROUND 8 L SUB WOOFER 4
AUDIO OUT
SPEAKERS

Line Output setting

Use to select the audio down-mix method
when outputting Dolby Digital multi-channel
sound sources from the ANALOG AUDIO
1
OUT jacks.
SETUP
1 Press SETUP.
TOOLS
ENTER
2 Select 'Sound Setup', then press
ENTER.
ENTER
3 Select 'Line Output', then press
ENTER.
4 Select a setting.
Select one of the following:
• Lo/Ro(Stereo) – A simple stereo downmix
(left-only/right-only, or Lo/Ro) is output
(suitable for playback on a two-channel
stereo system or on headphones).
• Lt/Rt – A surround-compatible downmix
(left-total/right-total, or Lt/Rt) of Dolby
multichannel sources is output, (suitable
for Dolby Surround Pro Logic or other
matrix decoding).
The L.OUT indicator lights.
ENTER
5 Press to exit.