Pioneer LX03BD Operating Instructions Manual page 129

Additional information
Problem Check
Inputs of connected Is HDMI Control set to On?
TV and this receiver,
switches
automatically.
Player cannot be Is an AV receiver or amplifier
operated with remote connected to the CONTROL IN
control. terminal on the player's rear
panel?
Are you operating the remote
control from a point too far away
from the player?
Are the batteries dead?
Settings you have • Have you disconnected the
made have been power cord while the player's
cleared. power was on?
• Has there been a power
failure?
After a disc is Are there too many files
inserted, Loading recorded on the disc?
stays displayed and
playback does not
start.
 is displayed in file
names, etc.
Is Hybrid Disc Playback
The DVD layer of BD
and DVD hybrid discs properly set?
cannot be played.
The CD layer of BD Is Hybrid Disc Playback
and CD hybrid discs properly set?
cannot be played.
The Hybrid Disc
Is a disc set in the disc tray?
Playback setting
cannot be changed
(displayed in gray).
BDMV/BDAV Is a disc set in the disc tray?
Playback Priority
setting cannot be
changed (displayed in
gray).
Remedy
The inputs of the connected TV or this receiver may
automatically switch to the player when playback starts on
the player or the menu screen (Home Media Gallery, etc.) is
displayed. If you do not want the inputs of the connected TV
and/or this receiver to switch automatically, set HDMI
Control to Off (page 111).
Operate with the remote control of the device connected to
the CONTROL IN terminal.
Operate from within 7 m of the remote control sensor.
Replace the batteries (page 9).
If the power cord is disconnected or there is a power failure
while the player's power is on, the settings you have made
may be cleared. Always press  STANDBY/ON on the
player's front panel or  BD on the remote control and
check that POWER OFF has turned off from the player's
front panel display before disconnecting the power cord. Be
particularly careful when the power cord is connected to the
AC outlet on another device because the player turns off in
conjunction with the device. We recommend plugging the
power cord into a wall outlet whenever possible.
When a disc on which files are recorded is inserted,
depending on the number of files recorded on the disc,
loading may take several dozen minutes.
The characters that cannot be displayed on this player are
displayed in .
Set Hybrid Disc Playback to DVD (page 113).
Set Hybrid Disc Playback to CD (page 113).
The Hybrid Disc Playback setting cannot be changed when
a disc is set. Remove the disc, then change the setting.
The BDMV/BDAV Playback Priority setting cannot be
changed when a disc is set. Remove the disc, then change
the setting.
07
129
En