Table of Contents
Advertisement
Configuration
(Standalone)
Sound-Active
Mode
Sound Sensitivity
Auto Program
Program Speed
CORE™ 3x3 User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
1.
Connect the product to power.
2.
Turn the product on.
Never connect a product that is operating in any standalone mode (either Static,
Automatic, or Sound) to a DMX string connected to a DMX controller. Products in
standalone mode may transmit DMX signals that could interfere with the DMX
signals from the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
To set the sound sensitivity, follow the instructions below:
1.
Press <MENU> repeatedly until SEnS shows on the display.
2.
Use <UP> or <DOWN> to select the desired sound sensitivity (u 0–u100).
3.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To select an auto program, do the following:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER> and P 1–P 6 shows on the display.
3.
Use <UP> or <DOWN> to select the desired auto program.
4.
Press <ENTER>.
To set the auto program speed, follow the instructions below:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> or <DOWN> to select the desired auto program speed
(S 1–S100, slow to fast).
3.
Press <ENTER>.
Page 17 of 23
Advertisement
Table of Contents
