Using Macros - Integra DTR-6.9 Instruction Manual

Controlling Other Components—Continued

Using Macros

You can program the remote controller's Macro buttons
to perform a sequence of remote control actions.
Example:
To play a CD you typically need to perform the follow-
ing actions:
1. Press the [Receiver] button to select the Receiver
remote controller mode.
2. Press the [On/Standby] button to turn on the AV
receiver.
3. Press the [CD] button to select the CD input source.
4. Press the Play [ ] button to start playback on the
CD player.
You can program a Macro button so that all four actions
are performed with just one button press.
Making Macros
Each Macro button can store one macro, and each macro
can contain up to 32 commands.
Remote
Mode
Macro
1, 2
1 While holding down the
[Receiver] button, press and hold
down the Macro button [1] or [2]
until the [Receiver] button lights
up (about 3 seconds).
(3 seconds)
2 Press the buttons whose actions
you want to program into the
macro in the order you want them
performed.
For the CD example above, you'd press
the following buttons: [On/Standby],
[CD], Play [
Receiver
].
3
When you've finished, press the
Macro button again.
The Remote Mode button flashes
twice.
If you enter 32 commands, the process
will finish automatically.
Note:
If any of the buttons you used to make a macro are taught
new commands, the macro will no longer work properly
and will have to be made again.
Running Macros
Press the Macro [1] or [2] button.
The commands in the macro are trans-
mitted in the order in which they were
programmed. Keep the remote control-
ler pointed at the AV receiver until all
of the commands have been transmit-
ted.
Macros can be run at any time, regard-
less of the current remote controller
mode.
Deleting Macros
1 While holding down the
[Receiver] button, press and hold
down the Macro button whose
macro you want to delete until
the [Receiver] button lights up
(about 3 seconds).
(3 seconds)
2
Press the Macro button again.
The [Receiver] button flashes twice.
131