Integra DTR-6.9 Instruction Manual page 50

First Time Setup—Continued
6 After the 3rd to the 5th measure-
ment, the following screen
appears.
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [Enter].
Next:
Select "Next" to begin measuring
the next measurement position.
After the 6th measurement has been
taken, the procedure automatically
proceeds to step 7.
Finish (Calculate):
Select this if you don't want to
measure any more listening posi-
tions and are ready to calculate the
results, then go to step 7.
7 When the measurements are
complete, the following screen
appears.
8 When the calculations are com-
plete, the following screen
appears.
50
Auto Speaker Setup
Select [Next] to measure the next position,
or select [Finish] to calculate
the Audyssey MultEQ room EQ solution.
Next
Finish(Calculate)
Auto Speaker Setup
Calculating...
Auto Speaker Setup
Review SP Configuration
Subwoofer : No
Front : Full Band
Center : None
Surround : None
Surr Back : None
Surr Back Ch : - - -
Save
Cancel
Use the Up and Down [ ]/[ ] but-
tons to select an option, and then
press [Enter].
The options are:
Save:
Save the calculated settings and exit
the automatic speaker setup.
Cancel:
Cancel the automatic speaker setup.
Note:
You can view the calculated settings for
the speaker configuration, speaker dis-
tances, and speaker levels by using the
Left and Right [ ]/[ ] buttons.
9
If you selected "Save", the results are
saved, and the following screen
appears.
10 Disconnect the speaker setup
microphone.
Notes:
• When the automatic speaker setup is complete, the
"Equalizer Settings" (page 94) will be set to "
sey ".
• You can cancel the automatic speaker setup at any
point in this procedure simply by disconnecting the
setup microphone.
Auto Speaker Setup
Saving...
Auto Speaker Setup
Please, unplug Setup Mic.
Audys-