Using Easy Macros - Integra DTR-60.5 Instruction Manual

Using Easy Macros

By using Activities in Easy macro mode, you can
sequentially operate Integra/Onkyo components via
simple commands from a single-button press.
These commands are user-definable. See "Using
Normal Macros" (➔ page 94).
1 Press Activities (My Movie, My TV, or
My Music) to start the Easy macro command.
The default sequences of actions are described
below.
To change the related source component, see
"Changing the Source Components" shown later
in this chapter.
■
My Movie
First, the TV, the Integra/Onkyo
Blu-ray Disc
and the AV receiver are turned on. The input selector
is set to "BD/DVD". Finally the player starts
playback.
*1
*1 Depending on the start-up time of your Blu-ray Disc/DVD
player, the AV receiver may not activate this playback
command. In this case, press on the remote
controller.
■
My TV
First, the TV, the cable set-top box, and the AV
receiver are turned on. Then the input selector is set
to "CBL/SAT".
■
My Music
The Integra/Onkyo CD player and the AV receiver are
turned on. The input selector is set to "TV/CD".
Finally, the player starts playback.
Note
• While the Easy Macro command is being processed, you
cannot use other Activities. If you want to operate other
components, first press All Off and use the desired
Activities.
Turning Off the Components
This button turns off all components activated by the
Easy Macro mode.
1 Press All Off.
First, the related components stop and turn off.
Second, the AV receiver turns off. Finally, the TV
turns off (or enters standby mode).
*1 This step doesn't apply to My Music, with the default
settings.
*2
With some televisions, the power may not be turned off
(or enter standby mode).
Changing the Source Components
You can change the source components activated by
player,
the Easy Macro mode.
1
While holding down Remote Mode for the
playback component you wish to assign,
press and hold down the Activities to be
changed (My Movie, My TV, or My Music)
(about 3 seconds).
Activities flashes twice, indicating that the
change is complete.
Examples:
If you wished to use My Music to start the Integra/
Onkyo CD player, you would press and hold down
My Music (about 3 seconds) while holding down
TV/CD until it flashes twice.
*1*2
En-53
Restoring Default
You can restore Activities to the default settings.
1 While holding down Home, press and hold
down All Off until All Off lights (about 3
seconds).
2
Release Home and All Off, and press All Off
again.
All Off flashes twice.
Playback