Entering Remote Control Codes - Integra DTR-40.1 Instruction Manual

Controlling Other Components—Continued

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
Remote
Mode
Number
buttons
1
Display
2
(3 seconds)
3
Note:
The remote control codes provided are correct at the time
of printing, but are subject to change.
Look up the appropriate remote
control code in the separate
Remote Control Codes list.
The codes are organized by category
(e.g., DVD player, TV, etc.).
While holding down the Remote
Mode button to which you want
to enter a code, press and hold
down the [Display] button (about
3 seconds).
The Remote Mode button lights up.
Notes:
• Remote control codes cannot be
entered for the [Receiver] and
[Zone2] buttons.
• Only TV remote control codes can be
entered for the [TV] button.
• Apart from the [Receiver], [TV], and
[Zone2] buttons, remote control
codes from any category can be
entered for the Remote Mode but-
tons. However, these buttons also
work as input selector buttons
(page 56), so choose a Remote Mode
button that corresponds with the
input to which you connect your
component. For example, if you con-
nect your CD player to the CD input,
choose the [CD] button when enter-
ing its remote control code.
Within 30 seconds, use the num-
ber buttons to enter the 5-digit
remote control code.
The Remote Mode button flashes
twice.
If the remote control code is not entered
successfully, the Remote Mode button
will flash once slowly.
131