Assigning Listening Modes To Input Sources - Integra DTR-40.1 Instruction Manual

Advanced Setup—Continued

Assigning Listening Modes to Input Sources

You can assign a default listening mode to each input source that will be selected automatically when you select each
input source. For example, you can set the default listening mode to be used with Dolby Digital input signals. You can
select other listening modes during playback, but the mode specified here will be resumed once the AV receiver has been
set to Standby.
1
Press the [Receiver] button followed by
the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [ ]/[ ] buttons to
select "5. Listening Mode Preset", and
then press [Enter].
The "Listening Mode Preset" menu appears.
5. Listening Mode Preset
1. DVD/BD
2. VCR/DVR
3. CBL/SAT
4. GAME
5. AUX
3
Use the Up and Down [ ]/[ ] buttons to
select the input source that you want to
set, and then press [Enter].
The signal format selection menu appears.
5–1. Listening Mode Preset
Analog/PCM
DolbyDigital/DolbyDigitalPlus
DTS/DTS HighResolutionAudio
D.F. 2ch
D.F. Mono
For TUNER input source only "Analog" will be
available. For NET input source only "Digital"
will be available.
Listening Mode Preset
Analog/PCM: With this setting, you can specify the listening mode to be used when an analog (CD, TV, LD,
VHS, MD, turntable, radio, cassette, cable, satellite, etc.) or PCM digital (CD, DVD, etc.) audio signal is
played.
DolbyDigital/DolbyDigitalPlus: With this setting, you can specify the listening mode to be used when a Dolby
Digital or Dolby Digital Plus format digital audio signal is played (DVD, etc.).
DTS/DTS HighResolutionAudio: With this setting, you can specify the listening mode to be used when a DTS
or DTS-HD High Resolution format digital audio signal is played (DVD, LD, CD, etc.).
D.F. 2ch: Specifies the default listening mode for 2-channel (2/0) stereo sources in a digital format, such as
Dolby Digital or DTS.
D.F. Mono: With this setting, you can specify the listening mode to be used when a mono digital audio signal
is played (DVD, etc.).
Multich PCM: Specifies the default listening mode for multichannel PCM sources input via a HDMI IN, such
as DVD-Audio.
Dolby TrueHD: Specifies the default listening mode for Dolby TrueHD sources, such as Blu-ray or HD DVD
(input via HDMI).
Notes:
• If you connect an input component (such as UP-A1
• This procedure can also be performed on the AV
DVD/BD
AllChSt
PLllxMovie
Neo:6
PLllxMovie
FullMono
4
Use the Up and Down [ ]/[ ] buttons to
select the signal format that you want to
set, and then use the Left and Right [ ]/
[ ] buttons to select a listening mode.
5
When you've finished, press the [Setup]
button.
The setup menu closes.
Dock that seated iPod) to the UNIVERSAL PORT
jack, you can assign only "Analog" to Port input
source.
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
103