Integra DTR-40.1 Instruction Manual page 55

First Time Setup—Continued
❏ Speaker Matching Error!
MultEQ: Auto Setup
Speaker Matching Error!
Retry
Cancel
The number of speakers detected on the second mea-
surement and later was different to the number
detected on the first measurement.
Make sure speakers that could not be detected are
connected properly.
Retry: Return to step 2 and try again.
Cancel: Cancel the room correction and speaker setup.
❏ Writing Error!
MultEQ: Auto Setup
Writing Error!
Retry
Cancel
This message appears if saving fails.
Try saving again. If this message appears after 2 or 3
attempts, the AV receiver is probably malfunctioning.
Contact the dealer from whom you purchased this unit.
Retry: Return to step 2 and try again.
Cancel: Cancel the room correction and speaker setup.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during
the room correction and speaker setup, follow the
directions on pages 91 to 93.
Notes:
• Please note that THX recommends any THX main
speakers be set to "80Hz(THX)". If you set up your
speakers using Audyssey MultEQ
and Speaker Setup, please make sure manually that
any THX speakers are set to 80 Hz (THX) crossover
(see page 91).
• Sometimes due to the electrical complexities of
subwoofers and the interaction with the room, THX
recommends setting the level and the distance of the
subwoofer manually.
• Sometimes due to interaction with the room, you may
notice irregular results when setting the level and/or
distance of the main speakers. If this happens, THX
recommends setting them manually.
Using a Powered Subwoofer
If you're using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by Audyssey MultEQ Room Correction and
Speaker Setup.
If the "Subwoofer" appears on the "Review SP
Configuration" screen as "No", increase the subwoofer's
volume to the half-way point, set it to its highest
crossover frequency, and then try running
Audyssey MultEQ Room Correction and Speaker Setup
again. Note that if the volume is set too high and the
sound distorts, detection issues may occur, so use an
appropriate volume level. If the subwoofer has a low-
pass filter switch, set it to Off or Direct. Refer to your
subwoofer's instruction manual for details.
®
Room Correction
55