Installing The Log Set - Montigo HR38DF Installation, Operation & Maintenance Manual

H38df series gas fireplace
Table of Contents

Advertisement

H38DF Series Gas Fireplace
H38DF

Installing the Log Set

Installing the Logs:
The H38DF is supplied with a seven ceramic fibre log logset. Unpack
the logs and handle them very carefully.
Step 1. Remove the glass door as described on Page 15.
Rear / Bottom Log
Notch in Log
Pilot Assembly
Fireplace Base
Figure 35a. Placing Bottom Rear Log.
Step 2. Place the bottom Rear log as shown in figure 35a.
Align
Bottom Left Log
Fireplace Base
Figure 35b. Placing Bottom Right / Left Logs.
Step 3. Place the bottom Right and Left logs as shown in figure 35b.
Top
Left Log
Align Pins
Top Left
Log
Figure 35c. Top Left / Right Log.
Step 4. Place the Top Right log as shown in figure 35c. using the (4)
four alignment pins protruding from the top of the Right and Left
Bottom Logs, as shown in figure 35c. With these pins align the
Top Right and Left logs using the predetermined alignment holes
Page 18
Installation
Air Inlets
Bottom Right Log
Right Log
Align Pins
Notch in Log
Top Right
the underside of the logs, as shown above, figure 35c insets.
Step 5. Place the Centre Front log , Figure 35d below, as shown using the
notch cast in the Bottom Rear log as shown in figure 35c above.
Figure 35d. Placing Centre Front Log.
Step 7. Place the Right Centre log as shown in figure 35e.
Align
Figure 35e. Placing Right Center Log.
Step 8. Place the Right Center log as shown using the notch in the Top
Right log as a guide, figure 35f.
Top
Figure 35f. Placing Embers.
Step 9. Place the Embers as shown in figure 35f.
Log
Arrange the ember chips on top of the burner tray. Care should be taken
when placing the embers, as blocked burner ports may cause an
incorrect flame pattern, carbon deposits and delayed ignition. Also,
the embers must never be placed in a way that obstructs any of
the air inlet ports, located at the rear of the burner, as shown in
figure 35b.
If logs are not placed properly, excessive sooting
will result.
The surface of the logs will crack due to the heat from
the flames. This is a normal occurrence.
Center Front Log
Centerline of Fireplace
Right Front
Log
Rest Log
Place Embers in this area
Cautions:
Groove
in Log
Part No. XG0147 - 011410

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

H38dfHl38df

Table of Contents