Positioning The Log Set; Installing The Log Set - Montigo B34DV Indoor Installation, Operation & Maintenance Manual

B-Series DV-2 Gas Fireplace

Installing the Log Set

Installing the Logs:
The B-Series DV2 is supplied with five ceramic fibre logs. Unpack the
logs and handle them very carefully.
1. Remove the door cover and the glass door.
2. Place the Back log onto the back log rest as shown below in figure
29. The log has a lip on the bottom which fits into the slot on the
log rest.
3. Place the Front log onto the front log rest as shown in figure 29.
Center the log from side to side, and push it against the back of the
log rest. Carefully push the log onto the metal spikes on the log rest.
4. Place the top logs in position as shown in figure 29a, place the
centre log down first, then the right and left logs.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Figure 29. Positioning for the front and back logs.
ositioning the
n t ing the og :
are resting on the log rests and are not covering the burner ports. he
Figure 29a. Proper log placement.
. l l a
f logs are not placed properly excessive sooting will
n
result.
he surface of the logs will crac due to the heat of the
n
Page 16
n t ing the og :
Installation
og et
a tions
Part No. XG0160 -141231