Playback of message in base unit
The display of the base unit always shows the total number of messages
in the memory, i.e. both old and new.
The numbers of the base unit's display will flash when there are new messages.
Playback will always begin with new messages.
1. Press
(base unit) to begin playback of all messages.
9
2. The following functions are available during playback:
Button
..................... Repeat/skip backwards.
88
..................... Skip to next message.
99
■
. ....................... Stop playback.
......................... Delete current message.
C
VOL + / -
. ........... Increase or decrease the volume.
3. Delete old messages to avoid reduction in memory capacity. Other messages will be saved.
Delete all messages
Deletion of all messages is only possible after playback: Press
Playback of messages in handset
The symbol
is shown at the bottom of the display when there are new
messages. Playback will always begin with new messages.
1. Press Menu. Scroll to TAM. Press OK.
2. Scroll to Play messages. Press OK.
3. Finish by pressing
The following functions are available during playback:
Command
2 .......................... Playback of messages/Stop
4 (<<) . .................. Repeat/skip to previous message
5 .......................... Erase single message during playback
6 (>>) . .................. Skip to next message
......................... Switch between handset/speaker
/
................... Volume control
}
{
Please note!
The
button flashes on the handset as well when there is some form of new message. Press button to
access the different messages. Delete old messages regularly to avoid filling up the memory!
Delete all old messages
1. Press Menu. Scroll to TAM. Press OK.
2. Scroll to Delete All. Press OK.
3. To confirm press Delete.
Function
.
L
Function
English
and then press
C
C
.