Basic Operation; Startup - Panasonic CF-61 Series Operating Instructions Manual

Basic Operation

Startup

Connecting the AC Adaptor
Startup procedure
First time computer is started only < For except CF-61KXF4BAM/E model>
License agreement
<<<<< LICENSE AGREEMENT UTILITY Ver. 3,0
Copyright (C) Matsushita Electric Industrial Co.,LTD. 1992-1996
Thank you for your purchase of Panasonic Product.
Before you use software programs furnished with this product,
Please read through "LIMITED USE LICENSE AGREEMENT" card.
If you AGREE to the card, press 'Y' and Enter.
If you NOT AGREE to it, press 'N' and Enter. All the software
installed on the hard disk will not be able to be used.
USER NAME:
Firstaid FD creation
* modifications and unforeseen situations. Make sure you have the
* respective software installation disks.
*
Firstaid FD 1
*
If you have the floppy disk(s) in hand, press any key and advance
*
the next step. Any data on these disks will, however, destroyed.
*
If the floppy disks are not currently available, turn off the pow
*
* until they are.
********************************************************************
Press any key to continue...
Ready to create Firstaid FD.
Insert a floppy disk in drive A and press any key.
10
The computer can be powered by either the AC
adaptor or battery pack.
3
2
1
MEMO
The supplied battery is not charged. When using the computer for the first time, be sure to charge
the battery pack before using the computor.
Connecting the AC adaptor automatically starts the charging process. Check the battery indicator
to confirm the current charging status.
Open Latch
2
Slide
1
Power Switch
Slide back and hold the power switch for one second to power
on the computer.
CAUTION
Slide
<For CF-61KXF4BAM/E model only>
When the power is turned on at the first time, before you use software
programs furnished with this product, please read through "LIMITED USE
LICENSE AGREEMENT" (
Read the message displayed on the screen, and follow the instructions.
>>>>>
Type your name.
Connect the AC cord to the AC adaptor.
1
Plug the AC cord into an AC outlet.
2
Plug the AC adaptor into the computer.
3
Slide the open latch.
1
Open up the display.
2
P.38). Then remove the seal.
NOTE
Make sure to create a "Firstaid FD" that will
allow you to reinstall the operating system if
necessary.
Do not switch power off or put the computer
into the suspend or hibernation mode while
the "Firstaid FD" is being created.
Blank 3.5-inch
floppy disk ( P.17)
NOTE
Use only the specified AC adaptor (CF-
AA159) with the computer.
CAUTION
Do not turn the computer off immediately
after turning it on.
Also, allow at least 10 seconds to elapse
after you have switched off the power and
want to turn the computer back on again.