Table of Contents
Advertisement
6.3.2 Configuring More Connections Advanced Setup
Use this screen to edit your P-660H-T1v3s's advanced WAN settings. Click the
Advanced Setup button in the More Connections Edit screen. The screen
appears as shown.
Figure 26 Network > WAN > More Connections: Edit: Advanced Setup
The following table describes the labels in this screen.
Table 16 Network > WAN > More Connections: Edit: Advanced Setup
LABEL
RIP & Multicast Setup
RIP Direction
RIP Version
Multicast
ATM QoS
ATM QoS Type
Peak Cell Rate
Sustain Cell Rate
P-660H-T1v3s User's Guide
DESCRIPTION
This section is not available when you configure the P-660H-T1v3s
to be in bridge mode.
Select the RIP direction from None, Both, In Only and Out
Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a multicast group. The
P-660H-T1v3s supports IGMP-v1, IGMP-v2 and IGMP-v3.
Select None to disable it.
Select CBR (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic. Select UBR (Unspecified Bit
Rate) for applications that are non-time sensitive, such as e-mail.
Select VBR-nRT (Variable Bit Rate-non Real Time) or VBR-RT
(Variable Bit Rate-Real Time) for bursty traffic and bandwidth
sharing with other applications.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to
find the Peak Cell Rate (PCR). This is the maximum rate at which
the sender can send cells. Type the PCR here.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term)
that can be transmitted. Type the SCR, which must be less than
the PCR. Note that system default is 0 cells/sec.
Chapter 6 WAN Setup
81
Advertisement
Table of Contents
