ZyXEL Communications P-2612HNU-F1 User Manual page 374

Appendix D Wireless LANs
Decide which device you want to be the registrar (usually the AP) and which you
1
want to be the enrollee (usually the client).
Look for the enrollee's WPS PIN; it may be displayed on the device. If you don't
2
see it, log into the enrollee's configuration interface and locate the PIN. Select the
PIN connection mode (not PBC connection mode). See the device's User's Guide
for how to do this - for the ZyXEL Device, see
Log into the configuration utility of the registrar. Select the PIN connection mode
3
(not the PBC connection mode). Locate the place where you can enter the
enrollee's PIN (if you are using the ZyXEL Device, see
Enter the PIN from the enrollee device.
Activate WPS on both devices within two minutes.
4
Note: Use the configuration utility to activate WPS, not the push-button on the device
itself.
On a computer connected to the wireless client, try to connect to the Internet. If
5
you can connect, WPS was successful.
If you cannot connect, check the list of associated wireless clients in the AP's
configuration utility. If you see the wireless client in the list, WPS was successful.
374
Section 6.4 on page 131.
Section 6.4 on page
P-2612HNU(L)-FxF User's Guide
131).