The 3G Backup Screen - ZyXEL Communications P-2612HNU-F1 User Manual

Chapter 5 Broadband
Table 10 Broadband Add/Edit: Bridge (Ethernet) (continued)
Label
Enable VLAN
Enter 802.1P
Priority
Enter 802.1Q
VLAN ID
Bridge Group
Apply
Back

5.3 The 3G Backup Screen

Use this screen to configure your 3G settings. Click Broadband > 3G Backup.
At the time of writing, the 3G card you can use in the ZyXEL Device is Huawei
E220.
Note: The actual data rate you obtain varies depending the 3G card you use, the
signal strength to the service provider's base station, and so on.
108
DESCRIPTION
Select this to add the VLAN Tag (specified below) to the outgoing
traffic through this connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag
into a MAC-layer frame that contains bits to define class of service.
Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic
through this connection. The greater the number, the higher the
priority level.
Type the VLAN ID number (from 1 to 4094) for traffic through this
connection.
Select the LAN/WLAN port(s) from which traffic will be forwarded to
the WAN interface directly.
Select a port from the Available LAN/WLAN Port(s) list and click
Add >> to add it to the Bridged LAN/WLAN Port(s) list.
If you want to remove a port from the Bridged LAN/WLAN Port(s)
list, select it and click Remove <<.
You cannot configure a QoS class for traffic from the LAN port which is
selected here.
Click Apply to save your changes.
Click Back to return to the previous screen.
P-2612HNU(L)-FxF User's Guide