ZyXEL Communications P-2612HNU-F1 User Manual page 192

Chapter 10 Quality of Service (QoS)
Table 41 Class Setup: Add/Edit (continued)
LABEL
Classification
Order
Forward to
Interface
DSCP Mark
To Queue
Criteria Configuration
Use the following fields to configure the criteria for traffic classification.
Basic
From Interface
Ether Type
Source
MAC Address
MAC Mask
IP Address
IP Subnet
Mask
Port Range
192
DESCRIPTION
Select an existing number for where you want to put this classifier to
move the classifier to the number you selected after clicking Apply.
Select Last to put this rule in the back of the classifier list.
Select a WAN interface through which traffic of this class will be
forwarded out. If you select Unchange, the ZyXEL Device forward
traffic of this class according to the default routing table.
This field is available only when you select the Ether Type check box
in Criteria Configuration-Basic section.
If you select Mark, enter a DSCP value with which the ZyXEL Device
replaces the DSCP field in the packets.
If you select Unchange, the ZyXEL Device keep the DSCP field in the
packets.
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen
already.
Select whether the traffic class comes from the LAN or a wireless
interface.
Select a predefined application to configure a class for the matched
traffic.
If you select IP, you also need to configure source or destination MAC
address, IP address, DHCP options, DSCP value or the protocol type.
If you select 8021Q, you can configure an 802.1p priority level and
VLAN ID in the Others section.
Select the check box and enter the source MAC address of the packet.
Type the mask for the specified MAC address to determine which bits
a packet's MAC address should match.
Enter "f" for each bit of the specified source MAC address that the
traffic's MAC address should match. Enter "0" for the bit(s) of the
matched traffic's MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
Select the check box and enter the source IP address in dotted
decimal notation. A blank source IP address means any source IP
address.
Enter the source subnet mask.
If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
P-2612HNU(L)-FxF User's Guide