Antenna Connection; Accessory Connections; External Speakers - Kenwood TM-D710GA Instruction Manual

ANTENNA CONNECTION

Before operating, you must fi rst install an effi cient, well-tuned antenna. The
success of your installation will depend largely on the type of antenna and its
correct installation. The transceiver can give excellent results if the antenna
system and its installation are given careful attention.
Use a low-loss coaxial feed line that also has a characteristic impedance of
50 , to match the transceiver input impedance. Coupling the antenna to the
transceiver via feed lines having an impedance other than 50  reduces the
effi ciency of the antenna system and can cause interference to nearby broadcast
television receivers, radio receivers, and other electronic equipment.
◆ Transmitting without fi rst connecting an antenna or other matched load may damage the
transceiver. Always connect the antenna to the transceiver before transmitting.
◆ All fi xed stations should be equipped with a lightning arrester to reduce the risk of fi re, electric
shock, and/or transceiver damage.
Antenna terminal

ACCESSORY CONNECTIONS

■ External Speakers

If you plan to use external speakers, choose speakers with an impedance of 4
 to 8  (standard is 8 ). The external speaker jacks accept a 3.5 mm (1/8")
mono (2-conductor) plug.
There are 2 speaker jacks on the rear of the transceiver: SP 1 and SP 2.
Feed line connector
SP 2 jack
To antenna
SP 1 jack
External speakers
7