Operation Panel Installation; Power Cable Connection - Kenwood TM-D710GA Instruction Manual

■ Operation Panel Installation

Note: Install the operation panel in a location where it
can easily receive satellite signals.
Install the operation panel so that it is standing
perpendicular.
Do not install the bracket close to an air bag.
1 Clean and dry the installation location.
2 Remove the release paper from the base
of the panel bracket, then secure it in place
using the 3 supplied self-tapping screws.
• Allow the panel to set for a while, to ensure
it remains fast. Otherwise, vibrations may
occur.
• After removing the release paper, it cannot be
reused.
3 Attach the panel holder to the panel bracket
using the 2 supplied SEMS screws.
4 Attach the operation panel to the panel
holder so that it locks in place.

■ Power Cable Connection

Be sure to use a 12 V vehicle battery that has suffi cient current capacity. If
the current to the transceiver is insuffi cient, the display may darken during
transmission or the transmit output power may drop excessively. Never
connect the transceiver to a 24 V battery.
Engine compartment
Black ( ) cable
Fuse holder
12 V vehicle
battery
Red (+) cable
Rubber grommet
Passenger compartment
DC power cable
Tapping screw
(4 mm x 12 mm)
Flat washer
Adhesive tape
Panel holder
Fuse holder
Panel
bracket
SEMS screw
(M4 x 10 mm)
3