Automatic Antenna Tuner Unit Installation; Automatic Antenna Tuner Connection - Kenwood TS-850S Instruction Manual

7-8. AT -850 AUTOMATIC ANTENNA TUNER UNIT INSTALLATION
1. Remove the top cover of the transceiver. Refer to
Section 6-6-1.
2. Remove the shield cover of the filter unit.
3. Carefully remove the coaxial cable.
4. Attach the AT -850 and screw it on.
Coaxial cable
5. Attach the cables from the AT -850 as shown.
6. Replace the shield cover and the top cover.
7-9. AT -300 AUTOMATIC ANTENNA TUNER CONNECTION
When the AT -300 is connected to this unit, slide switch SW1 on the back to EXT. The built-in antenna tuner will
then not operate. Use the PS-52 DC power supply when connecting the AT-300 to.this transceiver.
70