Table of Contents
Advertisement
Setting the Starting Address
This DMX mode enables the use of a universal DMX controller device. Each fixture requires a start address
from 1~512. A fixture requiring one or more channels for control begins to read the data on the channel
indicated by the start address. For example, a fixture that uses six DMX channels and was addressed to start
on DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, and 105. Choose start
addresses so that the channels used do not overlap, and note the start address selected for future reference.
If this is your first time addressing a fixture using the DMX control protocol, we suggest jumping to the
"Appendix" section and reading the heading "DMX Primer". It contains very useful information that will help you
understand its use.
General Troubleshooting
S
YMPTOM
· Excessive circuit load
Breaker/Fuse
· Short circuit along the power
keeps blowing
wires
· No power
Device does not
power up
· Loose power cord
· Wrong DMX addressing
· Damaged DMX cables
· Wrong polarity settings on the
Fixture is not
controller
responding to
DMX
· Loose DMX cables
· Faulty DMX interface
· Faulty Main PCB
· Non DMX cables
· Bouncing signals
· Long cable / Low level signal
Loss of signal
· Too many fixtures
· Interference from AC wires
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support.
Contact Us
World Headquarters
CHAUVET®
General Information
Address:
Voice:
Fax:
Toll free:
Technical Support
Voice:
Fax:
Email:
World Wide Web
COLORtube™ 3.0 EQ User Manual Rev. 3
P
C
(
)
OSSIBLE
AUSE
S
5200 NW 108th Avenue
Sunrise, FL 33351
(954) 577-4455
(954) 929-5560
(800) 762-1084
(954) 577-4455 (Press 4)
(954) 756-8015
tech@chauvetlighting.com
www.chauvetlighting.com
P
A
OSSIBLE
· Check total load placed on the electrical circuit.
· Check for a short in the electrical wiring (internal and/or
external).
· Check for power on Mains.
· Check power cord
· Check Control Panel and unit addressing
· Check DMX cables
· Check polarity switch settings on the controller
· Check cable connections
· Replace DMX input
· Replace Main PCB
· Use only DMX compatible cables
· Install terminator as suggested.
· Install amplifier right after fixture with strong signal.
· Install an optically coupled DMX splitter after unit #32.
· Keep DMX cables separated from power cables or
black lights.
United Kingdom & Ireland
CHAUVET® Europe Ltd.
General Information
Address:
Unit 1C
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice:
+44 (0)1773 511115
Fax:
+44 (0)1773 511110
Technical Support
Email:
uktech@chauvetlighting.com
World Wide Web
www.chauvetlighting.co.uk
(
)
CTION
S
Page 19 of 22
Advertisement
Table of Contents
