Generator Shut-Down Procedure - MULTIQUIP WHISPERWATT DCA10SPX4 Operation And Parts Manual

DCA10SPX4/DCA10SPXU4 — GENERATOR SHUT-DOWN PROCEDURES
WARNING - SHUTTING DOWN THE GENERATOR
NEVER stop the engine suddenly except in an emergency.
Normal Shutdown Procedure
To shutdown the generator use the following procedure:
1. Place both the main, GFCI, and aux. circuit breakers
as shown in Figure 20 to the OFF position.
2. Set the Speed Control Switch to the START/IDLE
position as shown in Figure 22 and let the engine cool
for 3-5 minutes with no load applied.
3. Turn the ignition key counter-clockwise to the STOP
position. When the engine has stopped, remove key.
Place key in a safe place where it will not be lost.
4. Inspect entire generator for any damage or loosening of
components that may have occured during operation.
DCA10SPX4/DCA10SPXU4 — OPERATION AND PARTS MANUAL — REV. #0 (08/05/09) — PAGE 31
Emergency Shutdown Procedure
1. Turn the ignition key counter-clockwise to the STOP
position. When the engine has stopped, remove key.
Place key in a safe place where it will not be lost.
2. Place both the main, GFCI, and aux. circuit breakers
as shown in Figure 20 to the OFF position.
1