Generator Start-Up Procedure - MULTIQUIP WHISPERWATT DCA10SPX4 Operation And Parts Manual

DCA10SPX4/DCA10SPXU4 — GENERATOR START-UP PROCEDURE
5. The ammeter (Figure 25) will indicate zero amps with
no load applied. When a load is applied, the ammeter
will indicate the amount of current that the load is
drawing from the generator.
Figure 25. Ammeter (No Load)
6. Set the Speed Control Switch to the RUN position
(Figure 26).
Figure 26. Speed Control Switch (RUN)
7. Place the main , GFCI , and aux . (Figure 27) circuit
breakers on the control panel in the ON position.
Figure 27. Main, GFCI, and Aux.
Circuit Breakers (ON)
PAGE 30 — DCA10SPX4/DCA10SPXU4 — OPERATION AND PARTS MANUAL — REV. #0 (08/05/09)
8. The generator's AC-voltmeter (Figure 28) will display the
generator's output in VOLTS. If the voltage is not within
the specified tolerance, use the voltage adjustment
control knob (Figure 29) to increase or decrease the
desired voltage.
Figure 28. Voltmeter
9. Use the voltage adjustment control knob (Figure 29) to
increase or decrease the desired voltage
Figure 29. Voltage Adjust Control Knob
10. Observe the generator's ammeter (Figure 30) and verify
it reads the anticipated amount of current with respect
to the load. The ammeter will only display a current
reading if a load is in use.
Figure 30. Ammeter (Load)
11. The generator will run until manually stopped or an
abnormal condition occurs.