Response; Pulse Width; Rtsi; Trigger Lines - National Instruments AT-MIO/AI E Series User Manual

Bus Interface
Power Requirement
Physical
Environment
National Instruments Corporation
Appendix A
External input (PFI0/TRIG1)
Impedance................................... 10 k
Coupling ..................................... DC
Protection.................................... -0.5 to Vcc +0.5 V when
Accuracy ........................................... 1% of full-scale range
Digital Trigger
Compatibility .................................... TTL
Response ........................................... Rising or falling edge
Pulse width........................................ 10 ns min

RTSI

Trigger Lines..................................... 7

Type .................................................. Slave
+5 VDC ( 5%) .................................. 1.2 A
Power available at I/O connector....... +4.65 VDC to +5.25 VDC
Dimensions
(not including connectors) .............. 33.8 by 9.9 cm (13.3 by 3.9 in)
I/O connector .................................... 68-pin male SCSI-II type
Operating temperature ....................... 0 to 55 C
Storage temperature........................... -55 to 150 C
Relative humidity .............................. 5% to 90% noncondensing
Specifications for AT-MIO-16XE-10 and AT-AI-16XE-10
configured as a digital signal
35 V when configured as an
analog trigger signal or disabled
35 V powered off
at 1 A
A-25 AT-MIO/AI E Series User Manual