Appendix A
Specifications for AT-MIO-16E-10 and AT-MIO-16DE-10
AT-MIO/AI E Series User Manual
Data transfers.....................................DMA, interrupts,
DMA modes.......................................Single transfer
Transfer Characteristics
Relative accuracy (INL)
After calibration................................. 0.3 LSB typ, 0.5 LSB max
Before calibration .............................. 4 LSB max
DNL
After calibration ......................... 0.3 LSB typ, 1.0 LSB max
Before calibration ....................... 3 LSB max
Monotonicity .....................................12 bits, guaranteed after
Offset error
After calibration ......................... 1.0 mV max
Before calibration ....................... 200 mV max
Gain error (relative to internal reference)
After calibration ......................... 0.01% of output max
Before calibration ....................... 0.5% of output max
Gain error
(relative to external reference) ...........0% to +0.5% of output max,
Voltage Output
Ranges ............................................... 10 V, 0 to 10 V, EXTREF,
Output coupling .................................DC
Output impedance ..............................0.1
Current drive...................................... 5 mA max
Protection...........................................Short-circuit to ground
Power-on state ...................................0 V
programmed I/O
calibration
not adjustable
0 to EXTREF
(software selectable)
A-14
max
National Instruments Corporation