Quick Start Install; Connect All Of The Following Wires; Plug-In The Module; Auto Tach Learn - Ultra Start 1500 SERIES Installation Manual

QUICK START INSTALL

Step 1 - Connect All Of the Following Wires
6 Pin Power Connector
Yellow Starter Output
Green Heater Output
Red 12 power Input
Red 12 power Input
Blue Ignition 1 Output
White Selectable
14 Pin Power Connector
Black System Ground
Pink Brake Switch
White Park Lights
Green/White Hood Pin
Blue/White Tach
Manual Transmissions Only
Blue or Green
Black/White
NOTE: Manual Transmission units MUST be set into RESERVATION mode to remote start.
See page 10 for details.
Step 2- Plug-In The Module
Step 3- Auto Tach Learn
* The system will flash the park lights seven times if not tach learned and the start button is
pressed. The system must be tach learned before remote starting.
** If the LED's do not come on during tach learn, a proper tach signal was not detected
Note:
for tach adjustment.
Your Basic Install Is Complete!
NOTES:
1) If the unit does not start, check the starter is not in Tach Lock Out or in Program Mode.
Your Basic Installation is Now Complete!!
2) If the vehicle still does not start, check all connections and check for factory security.
6
Door Trigger Input
Park Brake
OFF
Status Leds
- High Current.
- High Current.
See page 5
Program Button
See Page 8